CutListFlow
Stock Bars
10(1 offcut)· $41
Length Yield90.5%
Waste 9.5%
Parts Placed
22/22
Crosscuts
18(5.3 ft)
Reusable Offcuts
6 offcuts
1D First-Fit Decreasing
Bar #12×4 Stud (8 ft / 96")96"
CutsAll (1)
100%
96"58-3/4"34-1/2"
Reusable Offcut
Bar Yield: 97.1% · 2 parts · 1 cuts
StepOperationAxisCut Span
#1Crosscut bar at 58-3/4"Bar Crosscut—

CutListFlow · 1D Linear Cutting Stock Calculator

1D Linear Cut List Calculator for Lumber, Pipe & Extrusions

Optimize 1D linear cuts across mixed 8 ft, 10 ft, 12 ft, 2440 mm, 3000 mm, or 6000 mm stock lengths. Minimize wasted bar ends, deduct chop-saw blade kerf accurately, and burn leftover offcuts first.

1D Linear Optimization Specifications

Default Mode
Opens directly in 1D Linear mode with mixed stock lengths and shop offcuts preloaded
Supported Stock Lengths
8 ft (96"), 10 ft (120"), 12 ft (144"), 2440 mm, 3000 mm, 6000 mm (6m) or custom lengths
Solver Engine
Exact subset bin-completion combined with First-Fit Decreasing (FFD) across kerf and end-trim rules
Materials Covered
2×4 / 2×6 dimensional lumber, T-slot aluminum extrusion, EMT conduit, steel tube, and crown molding

Mix Multiple Bar Lengths & Remnants

Combine 8 ft and 10 ft boards—plus short 38" shop offcuts—in the same optimization so short leftovers are consumed before new bars.

Exact Chop-Saw Kerf Subtraction

Every crosscut accounts for blade width between consecutive pieces so your last cut never comes up 1/4" short.

Zero Part Limits & Printable Shop List

Import dozens of framing or metal extrusion lengths via CSV/Excel and print a clean per-bar crosscut checklist for the miter saw.

1D Linear Cut List FAQ

How does 1D linear optimization differ from 2D plywood nesting?
1D linear mode optimizes cuts along a single length axis—ideal for 2×4 studs, aluminum extrusions, pipes, and trim—while 2D mode optimizes length and width on flat panels.
Can I enter both 8 ft and 12 ft boards so the optimizer picks the cheapest mix?
Yes. Add multiple stock lengths with their unit costs and quantities, and the solver automatically tests combinations to minimize waste and bar count.
Does it deduct miter saw or cold saw kerf between every cut?
Yes. Configure Kerf once in the top toolbar (e.g. 1/8" or 3 mm) and every adjacent cut on a bar deducts the exact blade thickness.
Can I add leftover drops back into inventory?
Yes. Any bar drop above your minimum offcut threshold appears in the Reusable Offcuts tab with a + To Stock button.